Detection and troubleshooting of common faults of Hydraulic Dumping Tricycle

A Hydraulic Dumping Tricycle is a vehicle that uses a battery as its power source and converts electrical energy into mechanical energy for movement through controllers, motors and other components to control the size of the current and change the speed. Then, the inspection of Hydraulic Dumping Tricycle mostly focuses on checking the battery, vehicle controller and other components.

If the vehicle is out of power, first check whether the power supply has power. If not, check whether the fuse is good. If the fuse is normal and the power supply is out of power, check whether the internal electrode connections of the power supply are loose and whether the battery is open circuit. If the power supply is powered, check whether the power cord and power lock are normal;
The vehicle has electricity, but the motor does not rotate. At this time, short-circuit the positive red line of the handlebar and the speed yellow line of the handlebar on the controller. If the motor is running normally, the motor and controller are good. If the motor does not rotate, then The motor is broken or the controller is broken; if the motor and controller are normal but the motor does not rotate, it may be a problem with the handlebar and brake handle;
Batteries, that is, batteries, should also be inspected regularly and at fixed points: once every 2-3 months in winter and once a month in summer. Pay attention to whether the battery liquid level is below the marking line. Once the plate is exposed, it should be replenished with distilled water in time;
Regularly check the rear axle gearbox for oil leakage, low oil, and whether the sealing gasket is damaged, and replace the sealing gasket and replenish lubricating oil in a timely manner if necessary;
Add lubricating oil to the gearbox, motor sprocket, and chain regularly. If the wear is serious, replace it in time to avoid affecting normal use;
The bolts on Hydraulic Dumping Tricycle should be tightened regularly to check whether they are loose or falling off, and apply anti-rust liquid appropriately to avoid difficulties in later maintenance due to rust of the screws.