How to solve problems when using Tricycle Motorcycle

1. There are cracks or blisters in metal pipe fittings. You can intercept the break and find a plastic pipe sleeve with a suitable inner diameter and tightness to join it, and tie both ends with thin wire; you can also temporarily apply soap or tie tape on the oil leakage area.

2. The oil pump diaphragm is ruptured. You can patch it layer by layer, or you can cut it into a piece with oilcloth, plastic film, etc. and clamp it on the diaphragm for use. If the gap between the rocker arm and the outer rocker in the oil pump is too large, fill the gap with iron sheets, iron wire or hole pins, and tie it tightly with thin iron wire.
3. The valve spring of the Tricycle Motorcycle is broken. The two broken spring sections can be swapped so that they are opposite to each other, and then reassembled for use; if broken into multiple sections, the valve clearance adjustment screw can be loosened to close the valve and cut off the oil supply to the cylinder to stop it from working. .
4. The fan belt is broken. You can drill a small hole at each end of the broken part of the fan belt and tie it with thick iron wire for temporary use; you can also twist several strands of rope into one to replace the fan belt, etc., sandwich the rope ends in the middle, and then tie it tightly with iron wire.
5. The Tricycle Motorcycle fan blade was broken. If only one piece is broken off, you can detach the piece on the opposite side to keep the fan running smoothly. If the fan blades are severely damaged, they can be replaced with blades from a household fan and installed backwards on the fan bracket.
6. Water vapor leaks from the cylinder head. If it is caused by water suffocation, you can use an iron-tipped iron rod to suffocate the water on the raised part in the water, and then tap it with a hammer a few times to expand it. If it is caused by rust, you can use glue, thick The cloth is pasted layer by layer.
7. The radiator of the Tricycle Motorcycle is leaking. When there is a small amount of water leakage in the inlet and outlet hoses, it can be wrapped with tape or cloth strips coated with soap solution, and then tied tightly with iron wire or string. When the breakage is serious, you can disassemble the hose, cut off the fragments, and tie them tightly with suitable bamboo tubes or strings; when there are holes in the upper and lower water chambers of the radiator, you can stick multiple layers of tape to block them, or use cotton wood to block them, block it with wooden blocks and tie them tightly; when the radiator copper pipe leaks slightly, you can use soap to plug it; when it leaks, you can pinch the leaking copper pipe.