Main Factors Affecting Power Outage of Special Tricycle

Today, the use of Tricycle Motorcycle can be seen everywhere on the construction site. Its appearance greatly facilitates the engineering construction industry and improves work efficiency, so it is loved by many engineering users. There will always be some problems when the machine is used for a long time. The common one is the power failure of the tricycle. Faced with this problem, many users have a headache. Today, let`s talk about some reasons that will cause the power failure of the Tricycle Motorcycle.

①The connection line of the Tricycle Motorcycle battery. If the battery's connecting wire screw is loose, poor contact or broken, such as a simple battery installed under the pedal, pressing the broken wire can power the battery compartment cover, but if there is a bump across it, the power will be cut off.
②The air switch, if it is used for a long time, when the current of the air switch is less than the current of the Special Tricycle, the air switch will jump off. Of course, if the main wire screws on both sides of the air switch are not tightened, they will burn black and cause the air switch to trip.
③The lock cylinder of the electrical switch is loose. After a long time, the lock cylinder is broken and the connection is not good. When vibrating, the lock contact is bad and the power is cut off. Some locks have many keys strung together, which can break the cylinder even more and cause a power outage.
④Tricycle Motorcycle wiring problem, whether the battery connection line is in bad contact, the middle of the line from the battery to the lock, the negative line of the battery, etc. Check the wiring of the head-turning, the place that is easy to break. If the watch does not light up and the car does not move, the problem may be the above factors. If the watch does not light up, but the car can still drive, then there may be a problem with the watch`s connection line, such as whether the positive and negative electrodes of the watch are in poor contact, or whether the solder joints on the internal circuit board of the watch are loose.