Tips on using Tricycle Motorcycle

Tricycle Motorcycle are mainly used for loading and discharging slag in water diversion tunnels, replacing tractors and agricultural vehicles. Tricycle Motorcycle have the advantages of small size and large shipping capacity. Tricycle Motorcycle can be seen in many areas. When they first started using Tricycle Motorcycle, many people did not understand some of the techniques for using Tricycle Motorcycle, which often caused damage to the Tricycle Motorcycle. In order to avoid everyone For blind use, here are six tips for using Tricycle Motorcycle.

1. Do not store the Tricycle Motorcycle in a depleted state: The battery is strictly prohibited to be in a depleted state when stored. Depleted battery status means that the battery is not charged in time after use. When batteries are stored in a depleted state, sulfation is likely to occur. Lead sulfate crystals adhere to the plates, blocking the ion channels, resulting in insufficient charging and reduced battery capacity. The longer the battery is idle for a long time, the more serious the damage will be to the battery. Therefore, when the battery is idle, it should be recharged once a month, so as to better maintain the health of the battery.
2. Regularly inspect the Tricycle Motorcycle: During use, if the mileage of the Tricycle Motorcycle suddenly drops by more than ten kilometers in a short period of time, it is likely that one of the batteries in the battery pack has a broken grid or plate. Short circuit phenomena such as softening and loss of plate active material. At this time, you should go to the battery repair agency for inspection, repair or assembly in time. This can relatively extend the life of the battery pack and save money.
3. Avoid large current discharges on Tricycle Motorcycle: When starting, carrying people, or going uphill, please use pedals to assist Tricycle Motorcycle to avoid instantaneous large current discharges. High current discharge can easily lead to the formation of lead sulfate crystals, thereby damaging the physical properties of the battery plates.
4. Correctly grasp the charging time of Tricycle Motorcycle: Correct charging and charging time: During use, the charging time should be accurately grasped according to the actual situation, refer to the usual frequency of use and mileage, and pay attention to the capacity instructions provided by the battery manufacturer, such as and Supports charger performance and charging current. Size and other parameters govern charging frequency. Typically, the battery is charged overnight and the average charging time is about 8 hours. If it is a shallow discharge (the mileage after charging is very short), the battery will be fully charged very quickly. If you continue to charge it, it will overcharge, causing the battery to lose water and heat, thus shortening the battery life. So when the battery is discharged at a depth of 60%-70%. In actual use, it can be converted into riding mileage and necessary charging is performed according to the actual situation to avoid harmful charging.
5. Prevent Tricycle Motorcycle from being exposed to the sun: It is strictly forbidden to expose Tricycle Motorcycle to the sun. If the temperature is too high, the internal pressure of the battery will increase, and the battery pressure limiting valve will be forced to open automatically. The direct consequence is to increase the water loss of the battery, and excessive water loss of the battery will inevitably lead to a reduction in battery activity, accelerate the softening of the plate, and charge the case. Body heat, shell inflicted fatal injuries such as drumming and deformation.
6. Prevent the plug from heating up when charging the Tricycle Motorcycle: the charger output plug is loose, the contact surface is oxidized, etc., which will cause the charging plug to heat up. If the heating time is too long, the charging plug will short-circuit, directly damaging the charger and causing unnecessary losses. Therefore, when the above conditions are found, the oxide should be removed or the connector should be replaced.