How to deal with the noise caused by the Tricycle Motorcycle during use?

The Tricycle Motorcycle machine is composed of a hopper and a walking base. The material bucket is installed on the front of the tire traveling chassis, and the material is dumped by the gravity of the material in the bucket or the thrust of the hydraulic cylinder. Depending on the orientation, unloading can be divided into multiple unloading methods such as forward unloading, rotation unloading, side unloading, high support unloading and lift unloading. In order to adapt to the uneven road surface on site, avoid material scattering, and ensure accurate and fast unloading position, labor-saving operation, and good off-road and climbing capabilities, the Tricycle Motorcycle is required not to travel too fast.

During use, Electric Tricycle sometimes make unpleasant noises, which are of course very uncomfortable for the operator. So how do common noises from Tricycle Motorcycle occur and how to deal with them? Through several years of after-sales service Let's sum up some experience at work!
1. Electrical control box failure: The noise is generally dominated by current noise. It is generally believed that the current connector is faulty or some contacts are aging. The contacts should be replaced or re-reinforced to eliminate the noise.
2. Gear failure of the Tricycle Motorcycle: Stop immediately and check whether the gear of the Tricycle Motorcycle is operating normally, whether there is any damage on the tooth surface, whether the intermediate shaft is offset, causing abnormal noise in the gear, and noise caused by different faults. The difference is that when the gear is not operating normally, the noise of the entire gear is dull; when the gear is damaged, the noise is clear; when the intermediate shaft is offset, the noise is clear and accompanied by harsh sounds from time to time. When the gear fails, The use of Electric Tricycle is prohibited when not handled.
3. Reducer failure: first shut down the machine and check whether there is lubricating oil on the internal contacts. If the oil is insufficient or black oil needs to be replaced or refilled. If the gear is left motionless for a long time, the gears and tooth surfaces will be excessively worn or damaged.