Keep the inside and outside of the Tricycle Motorcycle battery clean

Tricycle Motorcycle are a means of transportation that we often use in engineering construction. Keeping the internal and external battery packs of tricycles clean is an important part of our use of tricycles.

Electrolyte, mud, dust, etc. spilling onto the outer surface of the Tricycle Motorcycle battery will cause short-circuit discharge. The outer surface of the battery, including the posts and chucks, needs to be wiped frequently to ensure that the battery surface is smooth and clean, and that the posts and chucks are in good and reliable contact. You can scrub with soapy water or alkaline water, but be sure to prevent soapy water or alkaline water from entering the battery, otherwise it will cause self-discharge. A better way is to apply a layer of butter on the outside of the wire connector to prevent electrohydraulic corrosion and connector oxidation, which will cause poor contact and make the circuit unstable.
When adding dielectric to electrolytic capacitors, the dielectric should be kept clean to prevent impurities from being mixed in. Open the vents on the liquid battery cover. The vents on the battery cover can release the gases inside the battery, namely flammable hydrogen and combustible oxygen, which are produced during charging. If the vents are blocked, the battery will generate heat in the chemical reaction. and gas, which will increase the temperature and pressure of the battery, and even cause the battery to burst.
Tricycle Motorcycle need to be charged scientifically: Tricycle Motorcycle batteries should generally use fixed voltage and fixed current charging methods. The characteristic of constant voltage charging is that the voltage remains constant during the charging process. During the charging process, when charging at a fixed voltage, the charging current decreases as the battery's electromotive force increases; if the battery's electromotive force is equal to the charging voltage, the charging current automatically drops to 0, and charging stops automatically. But the disadvantage is that under constant voltage conditions, the current cannot be adjusted freely.